Midmark M11 Ultraclave Dental Medical Steam Autoclave Sterilizer - Low Price | Atlas Resell Management

You are here

Midmark M11 Ultraclave Dental Medical Steam Autoclave Sterilizer - Low Price

Back to products

Midmark M11 Ultraclave Dental Medical Steam Autoclave Sterilizer - Low Price


Shop with confidence! This product has been fully inspected to avoid any buyer surprises. Read our in-depth product listing below.

Features: Automatic water filling, automatic steam pressure exhaust release, 30 minute drying phase, notifies staff that drying phase and sterilization are complete, dual gaskets on door assembly

Benefits: Reliable and proven design, easy to use, maintains maximum seal

Attention Buyer
This model may display code E001when the unit is plugged in for the first time. Press the "STOP" or "POWER" button to clear the code and operate the unit.

Your purchase will only include items shown in the listing photos.

Your purchase will NOT include: manufacturer warranty,  or any other accessories not shown or listed here.

This product is pre-owned and may not include the same accessories as a new, unused unit.

Return Policy: 30 Day Return Guarantee
Your satisfaction is important to us: Have your equipment installed by a factory-trained technician or Atlas-approved vendor to qualify for our return policy.
See our Terms and Conditions of Sale for details.

Product Condition Used, functional



Manufacturer: Midmark
Model: M11 UltraClave
Serial Number: ET1282
Power Requirements: 110V
Year: 1995
Sterilizer Type: steam chamber
Timer Function: features a basic timer with one timing option
Controls: digital control display
Chamber Depth: 18"
Chamber Diameter: 11"
Number of Trays: 4 trays
Cycle Count: Cycle count not available on this model.
Technician Testing Notes

  • Visually inspected, hooked up to a 120 volt power source, added distilled water and tested. Ran unit thru all it's preset sterilizing and drying cycles several times. Temperature tested to verify maximum sterilizing temperature using a Max Register Thermometer and found unit to maintain 273 F for an entire sterilizing cycle. Stripped unit down to the bare chassis and cleaned and rebuilt. Cleaned and flushed the reservoir tank and installed a new Drain Tube. Cleaned the sterilizing chamber and installed a new Heating Element, Water level Sensor, Door Gasket, Dam Gasket and Mesh Water Filter. Cleaned the Sterilizing Trays and Rack. Calibrated the Temperature and Pressure Sensors. Also installed into this unit were a new Steam Trap, Fill Valve Solenoid and Vent Valve Solenoid. Unit is fully functional.