Used Dental Model Trimmer & Lathe | Baldor Models 340, 342, 353T, 359T, 380T (1089) | Atlas Resell Management

You are here

Used Dental Model Trimmer & Lathe | Baldor Models 340, 342, 353T, 359T, 380T (1089)

Baldor polishing lathes is used to refine the cast restoration 

Baldor’s polishing lathes have features preferred by dentists, dental lab technicians, jewelers, lapidary, and others requiring precise trouble free polishing.  The ball bearings in all lathes are lubricated for life and sealed to prevent entry of dust and debris.

Features: 
  • Single or Dual phase depending on model
  • Base mounted on/off switch
  • Rubber feet to minimize vibration
  • Steel frame
Benefits: 
  • Lubefree
  • Easy to use
  • Ergonomic in design 
Limitations/Considerations: 
  • A flat must be filed on the shaft where the clutch set screw contacts the shaft. If this is not done, the set screw will raise a burr on the shaft and it will be very difficult to remove the clutch. File a flat on the right shaft about 3/8" from the end plate.
  • Always have a tool or shipping rod in the collet before moving the handle to the operating position. Move the handle counterclockwise until it stops.
Technical Specifications: 
  • Voltage: 
    115 - 240 Volts
  • RPM: 
    3600/1800
  • Shaft Diameter /Taper : 
    0.375/0.250 inch